asked on 22nd Sep 2011 | 1 Answers | Answer It!
This error message can occur if either of the following conditions exists:
• Your computer has hardware or software problems (hardware failure is the most common cause).
• You try to over clock the speed of your computer's processor (for example, you set a 150 MhZ processor to run at 187 MhZ).
The above STOP error means a trap occurred in kernel mode and the trap is either one the kernel is not allowed to have or is always fatal. The most common causes of a STOP 0x7F are:
• Low-level hardware corruption, such as corrupt memory (RAM)
• Mismatched memory modules
• A malfunctioning motherboard
To resolve this issue, use the appropriate method:
• If either software or hardware can cause a particular trap, a debug is required to determine which is the cause. If you suspect a hardware problem, try the following hardware troubleshooting steps:
1. Test the RAM in the computer by running the diagnostic software that is provided by the computer manufacturer. Replace any RAM that is reported as bad. Also, make sure that all the RAM in the computer is the same speed.
2. Try removing or swapping out controllers, cards, or other peripherals.
3. Try a different motherboard on the computer.
• If you are over clocking the speed of your processor, set it back to the speed at which it is designed to run.
• Check with the hardware vendor for any updated hardware drivers or BIOS updates, or both.
Here’s to Good Karma
asked on 11th Aug 2011 | 1 Answer
asked on 14th Sep 2011 | 1 Answer
asked on 8th Sep 2011 | 1 Answer
Here's to Good Karma